Loading...
> >

Blank Boi Eyes Where are they??

uncle808us_058ebb82b3uncle808us_058ebb82b3 Posts: 27
edited November 2014 in New Users

I notice in Blank Boi's body parts eyes are listed but I see no eyes. Are they there? Can they be there? What am I missing?:roll:

Bridge.jpg
800 x 800 - 290K
Post edited by uncle808us_058ebb82b3 on

Comments

  • Cris PalominoCris Palomino Posts: 11,151
    edited December 1969

    The product says there are morphs for the head. Did you install with DIM? If you do, you can find your product under installed and right click it. http://www.daz3d.com/forums/discussion/48570/

    Show Package Files will show you the files that were installed and where. The path will tell you where in DS they are, such as
    /People/Genesis 2 Male/Characters/Brandon.duf ....so under the category of People is Genesis 2 Male where you find Characters and Brandon. http://prntscr.com/557gpc

  • uncle808us_058ebb82b3uncle808us_058ebb82b3 Posts: 27
    edited December 1969

    Perhaps I was unclear. I have everything installed correctly. In the parameters there is available adjustments for eyes side to side as well as an adjustment for eyes up and down. But the figure has no eyes. (Blank Boi). So why are the adjustment dials there? I hope my question is a bit clearer this time. Thank you.

  • Cris PalominoCris Palomino Posts: 11,151
    edited December 1969

    You might IM the creator. I can see it has morphs, but none of the promos demonstrate their use, and I don't have it, I'm sorry.

  • uncle808us_058ebb82b3uncle808us_058ebb82b3 Posts: 27
    edited November 2014

    Hi: Thanks. I looked and looked but could not find a way to contact the creator. Went to the webpage but there was no contact information.
    I must be missing how to IM them. How is it done? Thanks again.

    Post edited by uncle808us_058ebb82b3 on
  • ChoholeChohole Posts: 33,604
    edited December 1969

    Top left of this forum panel you can see PM or you can look the PA up in the member list and then PM him from there
    http://www.daz3d.com/forums/member/27970

    BTW the only thing I can see in the included morphs, as per the product page is "HeadShape_EyeSockets"

  • wsterdanwsterdan Posts: 2,339
    edited November 2014

    chohole said:
    Top left of this forum panel you can see PM or you can look the PA up in the member list and then PM him from there
    http://www.daz3d.com/forums/member/27970

    BTW the only thing I can see in the included morphs, as per the product page is "HeadShape_EyeSockets"

    "Him" is actually a "her", and there are no actual eyes in the mesh. I think the eye morphs are there by default with the method Arpril used. It's possible she may have been planning a future update that would have actual eyes (and mouth) and put them there as a placeholder.

    There's definitely no eye geometry there, just a morph for the sockets.

    -- Walt Sterdan

    Post edited by wsterdan on
Sign In or Register to comment.