Loading...
> >

Pivot point in Poser

BurpeeBurpee Posts: 152
edited December 1969 in Poser Discussion

Is it possible to move your pivot point on a prop in Poser? I made an object in Hexagon but it does not retain the new pivot point that I gave it. The pivot point goes back to the center of mass center.

Comments

  • thatmoroboshi_5f704e2d19thatmoroboshi_5f704e2d19 Posts: 0
    edited December 1969

    Yes, open the Joint Editor (Ctrl+Shift+J) and enter the coordinates of the Center Point.

  • BurpeeBurpee Posts: 152
    edited December 1969

    Excellent! Thank you.

  • Richard HaseltineRichard Haseltine Posts: 100,926
    edited December 1969

    For a prop in Poser you just need to edit the x-, y- and z-offset parameters.

  • BurpeeBurpee Posts: 152
    edited December 1969

    Hi Richard, I the Poser manual I can only find the term 'offset parameters' pertaining to the uv mapping and texture. Is this what you mean or is there another area where I can make these changes?

  • BurpeeBurpee Posts: 152
    edited November 2012

    Located the joint editor through the Window tab and moved the center point that way. Never found the offset parameters that affected the center of mass. Thanks both for the help.

    Post edited by Burpee on
Sign In or Register to comment.