Loading...
> >

Repeat image for textures

richard_harris61_cff5471e49richard_harris61_cff5471e49 Posts: 23
edited December 1969 in The Commons

Hello,

This is probably quite simple but i can't fund the option.

I want to apply an image to a primitive object so that it repeats, rather than the image being stretched to fit the size of the object. where do I select this option?

Thanks

Richard

Comments

  • KatteyKattey Posts: 2,899
    edited May 2013

    brutus_1 said:
    Hello,

    This is probably quite simple but i can't fund the option.

    I want to apply an image to a primitive object so that it repeats, rather than the image being stretched to fit the size of the object. where do I select this option?

    Thanks

    Richard


    You need to look the Vertical and Horizontal tile options. In DS it is in Surface tab (select surface of the area you want to apply the image) - usually almost at the bottom. Input the number higher than 1 to have multiple repeats. In some DS versions vertical tile and offset might not work correctly.
    Post edited by Kattey on
  • richard_harris61_cff5471e49richard_harris61_cff5471e49 Posts: 23
    edited December 1969

    Thanks for that. I did actually look at that yesterday when looking to see if there was just a repeat option to select. I just set the tiling to 20 instead of 1 and does the job. Works better really. Thanks for your help. :)

    Richard

  • KatteyKattey Posts: 2,899
    edited December 1969

    You are welcome :)

Sign In or Register to comment.