Loading...
> >

Problems with Super Hero Suit for Genesis 2 Female(s) and Victoria 6

ComanderComander Posts: 52
edited December 1969 in Daz Studio Discussion

Hello everybody,
This morning I bought the set Superhero Suit for Genesis 2 Female (s) and Victoria 6. When I downloaded the product and wanted to try this works! Not right. This suit and boots did not fit to the figure. Very many pokes. When I take the Basic - Wear that comes bundled with 6 Victoria, was no problem. My question is: Is my DAZ STUDIO 4.6 per broken, or the product is faulty?
Can you help me? - Thanks in advance

Comments

  • PschelfhPschelfh Posts: 261
    edited December 1969

    There's a thread and a solution about it here : http://www.daz3d.com/forums/discussion/25097/

    Peter.

  • ChoholeChohole Posts: 33,604
    edited December 1969

    THere is a thread about this here http://www.daz3d.com/forums/discussion/25097/

  • MacSaversMacSavers Posts: 324
    edited December 1969

    I got M6 today and wanted to try out the Super Hero Suit I bought. I have some plans for this suit once I make my own textures for it, but I ran into the same issues everyone here has run into. I added the Subdivision Smoothing and it helped, but there are still issues with the mesh. I have a few poke throughs on both V6 and M6. I figured at least V6 would work fine, but not completely. Also, on M6, the bottom of the suit near the foot seems to come forward. That could be an autofit issue from M6, but if I want to use animation on these figures, this could pose a problem.

    Any ideas if SMAY has an update in the works to fix the few glitches?

    m6_with_v6_smay_superhero.jpg
    720 x 720 - 138K
Sign In or Register to comment.