Loading...
> >

Won't load older files... and where is the file log?

asatruteacher_190444d615asatruteacher_190444d615 Posts: 30
edited December 1969 in Technical Help (nuts n bolts)

I recently upgraded to Daz 4.6 and now it won't open any of my old "scene" files. It tells me that I need to see the file log but I can't find that. What do I need to do?

Comments

  • mjc1016mjc1016 Posts: 15,001
    edited December 1969

    In DS 4.6...Help > Troubleshooting > View Log File...

    How did you install 4.6?

    Did you remove your old content directories? Is 4.6 pointing to your old content if you didn't remove them?

  • JimmyC_2009JimmyC_2009 Posts: 8,891
    edited December 1969

    Log file can be viewed using Help > Troubleshooting > View Log File

    If DS is complaining about missing files from the 'data' folder, then you would need to find the data folder that was used when the scenes were saved.

  • asatruteacher_190444d615asatruteacher_190444d615 Posts: 30
    edited December 1969

    Thank you for the information on where to find the file log. I used the downloader to update my old Daz. I didn't remove ANYTHING. The files are showing up as Daz scenes, but I get a loading error after it reads it.

  • asatruteacher_190444d615asatruteacher_190444d615 Posts: 30
    edited December 1969

    Okay, now what do I look for in the log file to find out where the problem is?

  • mjc1016mjc1016 Posts: 15,001
    edited December 1969

    Basically, what I would do is try to load one of the 'bad' scenes, with the log open and then when it errors out refresh the log. The part that you need should be the very end.

  • asatruteacher_190444d615asatruteacher_190444d615 Posts: 30
    edited December 1969

    The log is generated as a document and won't stay open. However I tried to open one of the files and then views the log. At the very end I kept getting the following message repeated over and over:
    WARNING: Object::disconnect: No such signal QObject::currentValueChanged() in properties\controllers\dzerclink.cpp:1150
    WARNING: Object::disconnect: (sender name: 'Value')
    (Not sure which line goes on the top, but it's these two lines repeated over and over)

  • jestmartjestmart Posts: 4,449
    edited December 1969

    To get a 'clean' log file select all text and backspace to delete than save. Now try the scene than check the log.

Sign In or Register to comment.