Superhero suit for Genesis 2 in Carrara 8.5 pro

porthos62

Hi. I am trying to use the SuperHero Suit for Genesis 2 in Carrara. when I try to render I get the result shown in the attached JPG. (the suit doens't show and I just get 'patches')

Searching the DAZ forums, there is an issue in DAZ Studio with this and is resolved by smoothing or apply a 'push modifier'

Any help in getting this working in Carrara 8.5 pro would be glady appreciated.

Thanks in advance.

Diomede

There is a discussion of some issues with the supersuit in a thread on Genesis. Issues with Genesis 2 might be similar. See
http://www.daz3d.com/forums/discussion/30233/
In the thread, Bigh suggests saving the suit out of DS as a .duf file then using it in Carrara. You might try that. If it is primarily an issue with severe poke through, you might try making a morph for the figure that shrinks it slightly, or a morph for the suit that grows it slightly, or using the alpha channel to make the part of the figure covered by the suit invisible.

porthos62

Thanks for the info. I'll check out that thread.