Loading...
> >

Add to Auto-Fit

jarbeardjarbeard Posts: 53
edited December 1969 in Daz Studio Discussion

Hi folks,

Can anyone tell me where I might find the tutorial that describes how to add an item to auto-fit and how I can clone a figure to become a supported figure?

Thanks in advance for any help you can give.

John.

Comments

  • barbultbarbult Posts: 24,732
    edited March 2014

    Lots of related tutorials here that might help. I made clones following these instructions.

    Edited to fix link

    Post edited by barbult on
  • jarbeardjarbeard Posts: 53
    edited December 1969

    Thanks for that, It' ll take a bit of reading but it does look interesting.....:roll:

    I was beginning to give up hope of getting a reply...

    John.

  • barbultbarbult Posts: 24,732
    edited December 1969

    Sometimes threads fall down in the list and people don't notice them. We are not trying to ignore you. If the forum search engine were any good (and it isn't) you could search for the help you need. Sometimes a Google search will find things in the DAZ forum. You might try that sometime.

    Yes, the steps to create a clone are kind of complicated and it takes some effort to follow them exactly. That thread is a good place to ask questions about the process. Lots of people are following that thread and will see your post there.

  • frank0314frank0314 Posts: 14,254
    edited March 2014

    Google search is best for finding stuff in the forums.

    Post edited by frank0314 on
Sign In or Register to comment.