Loading...
> >

How do I save a new mesh that uses the G3 rig as a new model for use in DS

hellbornhellborn Posts: 59
edited August 2015 in Daz Studio Discussion

Hi.

 

I have created a new mesh and used transfer utility to transfer rig, groups etc from G3.

It needs som adjusments but basically it works fine and as expected.

Now, how do I save this so that I can load it up again just as any other figure.

There is after all a new mesh that has to be incorporated somehow?

 

Post edited by hellborn on

Comments

  • mjc1016mjc1016 Posts: 15,001

    File > Save As > Support Asset > Figure/Prop Assets

  • hellbornhellborn Posts: 59

    Thank's

  • larsmidnattlarsmidnatt Posts: 4,511
    edited August 2015

    how did the face rig go? That piece failed epically for me.

    the rest was gravy, but the face was broken if you tried to do any posing :(

    Post edited by larsmidnatt on
Sign In or Register to comment.