Loading...
> >

cannot take the glossiness off of g8 with n-g-s-anagenessis-2 applied

VicSVicS Posts: 1,273
edited December 2022 in Technical Help (nuts n bolts)

cannot take the glossiness off of g8 with n-g-s-anagenessis-2 applied

i tried every slider in surfaces , glossiness, top coat, glossy layered wieght

this image is with a spot lite, without a spotlite it is a little gloosy in some places but nowhere near as bad

will be good to know how to cut it down for both scenarios

thanks

2022-11-30_141814.png
404 x 538 - 493K
Post edited by Richard Haseltine on

Comments

  • Richard HaseltineRichard Haseltine Posts: 102,464

    Moved to Techncial Help - please post questions about products here, not in Daz Studio Discussion.

  • VicSVicS Posts: 1,273

    ok

  • robertswwwrobertswww Posts: 793

    @VicS To remove the glossiness, try lowering or turn to 0 (zero) your Dual Lobe Specular Weight, your Lobe Roughness controls, and/or your Base Bump.
    NOTE: If you don't see these controls, set your Base Mixing to PBR Metallicity/Roughness.

  • VicSVicS Posts: 1,273
    edited December 2022

    thanks Robert , will try later in day, tried it works fine, thanks again

    Post edited by VicS on
Sign In or Register to comment.