using V4 Hair morphs on Genesis 3

cory77_dad5a3bd45

how do u access the hair morphs on v4 hair once it is autofited to Genesis 3? Can't seem to select the neck part of the hairs where the morphs are located.

larsmidnatt

some products don't translate with morphs once autofitted. However you should be able to transfer the morphs from the original V4 hair to the new genesis fit one via the transfer tool. Are you familiar with the transfer utility?

cory77_dad5a3bd45

no i am afraid i am not. where can i get the utility? thanks in advance.

larsmidnatt

Not at home at the moment to work out the steps. but if I remember later I can write it up.

 

cory77_dad5a3bd45

thanks so much

mjc1016

Here's a pretty good write up...

http://www.daz3d.com/forums/discussion/1866/ramworks-tutorials-pp2-and-hr2-to-figure-painting-genesis-in-zbrush/p1

cory77_dad5a3bd45

thanks