Loading...
> >

Custom heels offset from foot after transferring rigging

comradenikola92comradenikola92 Posts: 0
in Technical Help (nuts n bolts)

I followed the attached procedure to the letter, and many others, and have found that the shoes are always offset to the side once finally set to fit. Online others have reported this (the third photo), but no resolution. I had to create the foot pose around which to model, and this is usually suggested by all of these tutorials, so that can't be the culprit?

Any ideas?

image (9).png
2765 x 540 - 123K
high_heel_wedges_pump_wip_04_by_keiku_dha0hyz-pre.jpg
1048 x 763 - 33K
image (8).png
1041 x 1310 - 951K
image (7).png
1807 x 1255 - 2M

Comments

  • crosswindcrosswind Posts: 6,969
    edited June 16

    You didn't make the shoes on a Base figure but a character, correct ?  If so, you need to re-import the shoes OBJ as a delta to update the AutoFollow FBM in the hidden properties of the shoes.

    As per the standard procedure, make shoes on Genesis x Base figure rather than a character...

    Besides, also check pjcm (cbs on G9) morphs in hidden properties of the shoes, you need to fixe them as well with such a Feet Pose.

    Post edited by crosswind on
Sign In or Register to comment.