Victoria V4 is not TExturing Correctly

Rowanessque

So the problem is when I load a pz2 onto V4 as in the example below look what happens :(

 

Why is this happening, with textures in 4.9 it never happened in the old versions.

Its not fixable either, you have to log off, log on and then start again which is to be honest frustrating to say the least.

 

 

 

 

 

 

 

 

Rowanessque

So I did what I usually do, start a clean slate and it was worse, why is 4.9 doing this :( it did it with Baby Genesis too, its really annoying.

mjc1016

Post a screenshot of the the Surfaces tab...pick the face and if needed split the list into two shots...

Rowanessque

just deleted 4.9 and going back to 4.5 if it happens again, I will post the screen shot, thanks for posting x